1.14 - February 17, 2011
- Added two sizes of MJPEG thumbnail streams

1.13 - October 15, 2010
- updated HTTP GET/PUT description
- removed HTTP POST
- corrected motion grid setting parameters

1.12 - September 3, 2010
- added new overlay parameters
- clarified image parameters per product type
- added unique Express video server image parameters
- added mirror/invert

1.11 - August 5, 2010
- added H.264 over RTP/RTSP

1.10 - May 26, 2010
- added H.264 motion detection information
- added H.264 frame rate
- added PTZ control
- added PTZ address and baud rate

1.09 - May 4, 2010
- documented MAC address read command

1.08 - April 6, 2010
- added H.264 port/protocol to info.cgi

1.07 - Februbary 12, 2010
- added h.264 streaming URI/URL
- added h.264 control parameters

1.06 - December 21, 2009
- added relay set
- added trigger input read

1.05 - November 17, 2009
- corrected motion_time description
- included motion detection JPEG header information
- added link to sample C++ probe code

1.04 - February 13, 2009
- expanded functionality of "haze" parameter
  (now acts as skew when "auto_haze" is enabled)

1.03 - June 11, 2008
- added Express 2/4 video servers
- additional mjpeg URL parameters (FPS and motion)
- added info.cgi
- added resolution list (info.cgi?resolutions)
- switched on/off parameters to 0/1 (on/off still supported)
- remove "disabled" parameter from imaging
- removed "debug" parameter from imaging
- removed resolutions lists from imaging
- added "ir_enable" parameter to imaging
- added "jpeg_size" parameter to imaging
- added "lowlight_dnr" parameter to imaging
- added "lowlight_preset" parameter to imaging
- added "lowlight_pixelrep" parameter to imaging
- added "lowlight_saturation" parameter to imaging
- added "lowlight_yuv" parameter to imaging
- added "lowlight_imagespeed" parameter to imaging
- removed Applet section
- added Motion section
- added "wx_temperature" parameter to wx
- added "wx_humidity" parameter to wx
- removed "ppp0_MACADDR" parameter from dial-out
- removed "eth0_DEVICE" parameter from network
- removed "GATEWAYDEV" parameter from network
- removed "eth0_ONBOOT" parameter from network

1.02 - May 8, 2008
- removed parsed header URL (still supported for backward compatibility)
- bug noted in resolution command
- added NetCam SC 1.3MP resolution list

1.01 - January 24, 2008
- added non-parsed-header MJPEG URL (http://<ip>/nph-mjpeg.cgi?0

1.00 - October 22, 2007
- first release